Allow the handle to rest at the side of the sensor head with the log button attached.įigure 19‑21. Note that the middle screw (if there is one) is shorter than the other two. Specifications and Features:Manufacturer Number: CH128' Working Length Rod with HandleBrass CoreBronze BristlesFor use on 12 Gauge Shotguns5/16-17 ThreadMade in the USA. Use a #1 Phillips head screwdriver to remove them. The screws are located on the back side of the handle, as shown in Figure 19‑21.Open the chamber, and turn the adjustment nut until it is free of the handle ( Figure 19‑20).įigure 19‑20.the 6400-09 Soil Chamber and the 6400-05 Conifer Chamber). The handle must be removed for certain service operations, and for installing certain chambers (e.g. To access, remove the bolt in the rear that serves as a hinge. A must-have for owners of AR-style rifles. This combo includes the Dewey Fixed Handle Brass Rod and the Dewey Chamber Brush.
Allows cleaning of recesses and hard to reach areas that attract grit and powder residue. The latch return spring is in the rear of the handle. The Dewey Rifle Chamber Brush and Rod is specifically designed for the proper maintenance of your AR chamber. It should never need any service, and the only reason you might have to deal with it is if the spring should fall out of place when the handle is disconnected. The latch return spring is shown in Figure 19‑19. Should the wire break, you can replace it (6564-057) or replace the entire assembly (6400-903). The catch rod can be re-bent with a pair of needle nosed pliers, if necessary. If it doesn’t, the chamber will not latch correctly.
The chamber catch rod should have a 90 degree bend at the top. The charging handle is also what a shooter uses if they need to clear a jam or. The AR-15 charging handle is what moves the AR's trigger into the ready position, charging the rifle and making it ready for use. Pro Shot 12 Gauge Chamber Brush with Handle, Black Visit the Pro Shot Store 55 ratings Price: 16. Hint: If you have trouble unlatching a chamber, just push the black handle piece to the left (looking down on it from the rear) as you squeeze the handle.įigure 19‑18. When it comes to building or using an AR-15, the charging handle may not seem like an important piece of machinery, but it is. If the rod isn’t far enough to the left ( Figure 19‑18) when the chamber is open, then you might have trouble getting it to unlatch.GUN II Operation and Maintenance Manual P/N: MN105 - TLN V2 November 08 REVISION HISTORY. If it becomes straightened, reach in with a pair of needle nosed pliers and re-bend it. Reproduction or diffusion of this document are forbidden without the prior written agreement of SERCEL MSD. This rod must have a 90 degree bend at the top, or the chamber will not latch correctly.There are a couple of latching problems that this rod can cause: The key to the latch mechanism is the chamber catch rod, that little wire shown in Figure 19‑18. If they get loose, tighten them ( Figure 19‑17). The handle is held on with two screws (or three, depending upon the instrument’s vintage).